2-399
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
license right-to-use activate
license right-to-use activate
Note This command only applies to Catalyst 4500-X and Supervisor Engine 7-E and 7L-E.
To activate PRTU licenses use the license right-to-use activate command.
license right-to-use activate feature-name [acceptEula]
Syntax Description
Defaults PRTU licenses are inactive
Command Modes privileged EXEC mode
Command History
Usage Guidelines Use this command to activate PRTU licenses that are inactive.
Downloading the license file from cisco portal and installing the license are not required. The PRTU
licenses are bundled with image. Because the PRTU license is of highest precedence, when the PRTU
license is activated, other license of the same feature switch to inactive state.
Examples The following example shows how to activate PRTU licenses:
Switch# license right-to-use activate entservices
Related Commands
feature-name Specifies the feature name (e.g., entservices, ipbase, lanbase)
acceptEula (Optional). Activates the PRTU license. The End User License Agreement is
accepted but does not display.
Release Modification
IOS XE 3.4.2SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
license right-to-use
deactivate
Deactivates the PRTU license