Cisco Catalyst 4500 Series Command Reference Guide

2-156
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug ip verify source packet
debug ip verify source packet
To debug the IP source guard messages, use the debug ip verify source packet command. To disable
the debugging output, use the no form of this command.
debug ip verify source packet
no debug ip verify source packet
Syntax Description This command has no arguments or keywords.
Defaults Debugging of snooping security packets is disabled.
Command Modes Privileged EXEC mode
Command History
Examples This example shows how to enable debugging for the IP source guard:
Switch# debug ip verify source packet
Switch#
This example shows how to disable debugging for the IP source guard:
Switch# no debug ip verify source packet
Switch#
Related Commands
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
ip dhcp snooping Globally enables DHCP snooping.
ip dhcp snooping limit rate Enables DHCP option 82 data insertion.
ip dhcp snooping trust Enables DHCP snooping on a trusted VLAN.
show ip dhcp snooping Displays the DHCP snooping configuration.
show ip dhcp snooping binding Displays the DHCP snooping binding entries.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E