Cisco Catalyst 4500 Series Command Reference Guide

2-95
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
class-map
class-map
To create a class map to be used for matching packets to the class whose name you specify and to enter
class-map configuration mode, use the class-map global configuration command. To delete an existing
class map and to return to global configuration mode, use the no form of this command.
class-map [match-all | match-any] class-map-name
no class-map [match-all | match-any] class-map-name
Syntax Description
Defaults No class maps are defined.
If neither the match-all nor the match-any keyword is specified, the default is match-all.
Command Modes Global configuration mode
Command History
Usage Guidelines Use this command to specify the name of the class for which you want to create or modify class-map
match criteria and to enter class-map configuration mode. Packets are checked against the match criteria
configured for a class map to decide if the packet belongs to that class. If a packet matches the specified
criteria, the packet is considered a member of the class and is forwarded according to the quality of
service (QoS) specifications set in the traffic policy.
After you enter the class-map command, the switch enters class-map configuration mode, and these
configuration commands are available:
• description Describes the class map (up to 200 characters). The show class-map privileged EXEC
command displays the description and the name of the class map.
• exit Exits from QoS class-map configuration mode.
• match Configures classification criteria. For more information, see the match (class-map
configuration) command.
• no Removes a match statement from a class map.
match-all (Optional) Perform a logical-AND of all matching under this class map. All
criteria in the class map must be matched.
match-any (Optional) Perform a logical-OR of the matching statements under this class
map. One or more criteria in the class map must be matched.
class-map-name Name of the class map.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E