Cisco Catalyst 4500 Series Command Reference Guide

2-348
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip source binding
ip source binding
To add or delete a static IP source binding entry, use the ip source binding command. To delete the
corresponding IP source binding entry, use the no form of this command.
ip source binding ip-address mac-address vlan vlan-id interface interface-name
no ip source binding ip-address mac-address vlan vlan-id interface interface-name
Syntax Description
Defaults This command has no default settings.
Command Modes Global configuration mode
Command History
Usage Guidelines The ip source binding command is used to add a static IP source binding entry only.
The no form of this command deletes the corresponding IP source binding entry. For the deletion to
succeed, all required parameters must match.
Each static IP binding entry is keyed by a MAC address and VLAN number. If the CLI contains an
existing MAC and VLAN, the existing binding entry will be updated with the new parameters; a separate
binding entry will not be created.
Examples This example shows how to configure the static IP source binding:
Switch# config terminal
Switch(config)# ip source binding 11.0.0.1 0000.000A.000B vlan 10 interface
fastethernet6/10
Switch(config)#
Related Commands
ip-address Binding IP address.
mac-address Binding MAC address.
vlan vlan-id VLAN number.
interface interface-name Binding interface.
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
show ip source binding Displays IP source bindings that are configured on the
system.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E