Cisco Catalyst 4500 Series Command Reference Guide

2-527
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
port-channel standalone-disable
port-channel standalone-disable
To disable the EtherChannel standalone option in a port channel, use the port-channel
standalone-disable command in interface configuration mode. To enable this option, use the no form
of this command.
port-channel standalone-disable
no port-channel standalone-disable
Syntax Description This command has no arguments or keywords.
Defaults The standalone option is disabled.
Command Modes Interface configuration mode
Command History
Usage Guidelines This command can only be used when the port channel protocol type is Link Aggregation Control
Protocol (LACP). It allows you to change the current behavior when a physical port cannot bundle with
an LACP EtherChannel.
Examples The following example shows how to enable the EtherChannel standalone option in a port channel:
Switch(config-if)# no port-channel standalone-disable
Related Commands
Release Modification
15.0(2)SG1 Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
show etherchannel Displays EtherChannel information for a channel.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E