Cisco Catalyst 4500 Series - Dscp (Netflow-Lite Exporter Submode)

2-232
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
dscp (netflow-lite exporter submode)
dscp (netflow-lite exporter submode)
To specify a CoS value for the NetFlow-lite collector, use the dscp command. To delete the value, use
the no form of this command.
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
dscp dscp-value
no dscp dscp-value
Syntax Description
Defaults 0
Command Modes netflow-lite exporter submode
Command History
Examples This example shows how to specify a CoS value for the NetFlow-lite collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
Display the exporter
Switch# show netflow-lite exporter exporter1
Netflow-lite Exporter exporter1:
Network Protocol Configuration:
Destination IP address: 5.5.5.6
Source IP Address: 5.5.5.5
VRF label:
dscp-value Specifies a DSCP value for the NetFlow-lite collector. Valid values from 0 to
63
Release Modification
15.0(2)SG Support for this command was introduced on the Catalyst 4948E and
Catalyst 4948E-F Ethernet switches.