EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1184 background imageLoading...
Page #1184 background image
2-1126
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
vmps server
vmps server
To configure the primary VLAN Membership Policy Server (VMPS) and up to three secondary servers,
use the vmps server command. To remove a VMPS server, use the no form of this command.
vmps server ipaddress [primary]
no vmps server ipaddress
Syntax Description
Defaults No primary or secondary VMPS servers are defined.
Command Modes Global configuration mode
Command History
Usage Guidelines The first server that you entered is automatically selected as the primary server whether or not primary
is entered. You can override the first server address by using primary in a subsequent command.
If a member switch in a cluster configuration does not have an IP address, the cluster does not use the
VMPS server that is configured for that member switch. Instead, the cluster uses the VMPS server on
the command switch, and the command switch proxies the VMPS requests. The VMPS server treats the
cluster as a single switch and uses the IP address of the command switch to respond to requests.
When using the no form without specifying the ipaddress, all configured servers are deleted. If you
delete all servers when dynamic-access ports are present, the switch cannot forward the packets from the
new sources on these ports because it cannot query the VMPS.
You can verify your setting by entering the show vmps command and examining information in the
VMPS Domain Server row.
Examples This example shows how to configure the server with IP address 191.10.49.20 as the primary VMPS
server. The servers with IP addresses 191.10.49.21 and 191.10.49.22 are configured as secondary
servers:
Switch(config)# vmps server 191.10.49.20 primary
Switch(config)# vmps server 191.10.49.21
Switch(config)# vmps server 191.10.49.22
Switch(config)#
ipaddress IP address or host name of the primary or secondary VMPS servers. If you specify
a hostname, the Domain Name System (DNS) server must be configured.
primary (Optional) Determines whether primary or secondary VMPS servers are being
configured.
Release Modification
12.1(4)EA1 Support for this command was introduced on the Catalyst 4500 series switch.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals