EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #421 background imageLoading...
Page #421 background image
2-363
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip wccp redirect
ip wccp redirect
To enable packet redirection on an inbound or outbound interface using Web Cache Communication
Protocol (WCCP), use the ip wccp redirect command in interface configuration mode. To disable
WCCP redirection, use the no form of this command.
ip wccp {web-cache | service-number} redirect {in | out}
no ip wccp {web-cache | service-number} redirect {in | out}
Syntax Description
Command Default Redirection checking on the interface is disabled.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines The ip wccp {web-cache | service-number} redirect in command allows you to configure WCCP
redirection on an interface receiving inbound network traffic. When the command is applied to an
interface, all packets arriving at that interface will be compared against the criteria defined by the
specified WCCP service. If the packets match the criteria, they will be redirected.
Likewise, the ip wccp {web-cache | service-number} redirect out command allows you to configure
the WCCP redirection check at an outbound interface.
Tips Be careful not to confuse the ip wccp {web-cache | service-number} redirect {out | in} interface
configuration command with the ip wccp redirect exclude in interface configuration command.
web-cache Enables the web cache service.
service-number Identification number of the cache engine service group; valid values are
from 0 to 254.
If Cisco cache engines are used in the cache cluster, the reverse proxy
service is indicated by a value of 99.
in Specifies packet redirection on an inbound interface.
out Specifies packet redirection on an outbound interface.
Release Modification
12.2(31)SG Support introduced on the Catalyst 4500 series switch.
IOS XE 3.2(0)SG
(15.0(2)SG)
Support extended to Supervisor Engine 6-E, Supervisor Engine 6L-E,
Catalyst 4900M, and Catalyst 4948E.
15.0(2)SG1 web-cache and service-number keywords supports on Supervisor Engine
6-E, Supervisor Engine 6L-E, Catalyst 4900M, and Catalyst 4948E.
IOS XE 3.3.0 SG
(15.1(1)SG)
Supported extended to Supervisor Engine 7-E and Supervisor Engine 7L-E.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals