EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #203 background imageLoading...
Page #203 background image
2-145
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug condition vlan
debug condition vlan
To limit the VLAN debugging output for a specific VLAN, use the debug condition vlan command. To
disable the debugging output, use the no form of this command.
debug condition vlan {vlan_id}
no debug condition vlan {vlan_id}
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines If you attempt to remove the only VLAN condition set, you will be prompted with a message asking if
you want to abort the removal operation. You can enter n to abort the removal or y to proceed with the
removal. If you remove the only condition set, it could result in the display of an excessive number of
messages.
Examples This example shows how to limit the debugging output to VLAN 1:
Switch# debug condition vlan 1
Condition 4 set
Switch#
This example shows the message that is displayed when you attempt to disable the last VLAN debug
condition:
Switch# no debug condition vlan 1
This condition is the last vlan condition set.
Removing all conditions may cause a flood of debugging
messages to result, unless specific debugging flags
are first removed.
Proceed with removal? [yes/no]: n
% Operation aborted
Switch#
vlan_id Number of the VLAN; valid values are from 1 to 4096.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(12c)EW Support for extended VLAN addresses added.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals