Cisco Catalyst 4500 Series - Show Idprom

2-701
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show idprom
show idprom
To display the IDPROMs for the chassis, supervisor engine, module, power supplies, fan trays, clock
module, and multiplexer (mux) buffer, use the show idprom command.
show idprom {all | chassis | module [mod] | interface int_name | supervisor | power-supply
number | fan-tray}
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines When you enter the show idprom interface command, the output lines for Calibration type and Rx
(receive) power measurement may not be displayed for all GBICs.
all Displays information for all IDPROMs.
chassis Displays information for the chassis IDPROMs.
module Displays information for the module IDPROMs.
mod (Optional) Specifies the module name.
interface int_name Displays information for the GBIC or SFP IDPROMs.
supervisor Displays information for the supervisor engine IDPROMs.
power-supply number Displays information for the power supply IDPROMs.
fan-tray Displays information for the fan tray IDPROMs.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(12c)EW Support for the power-supply, fan-tray, clock-module, and mux-buffer keywords
was added.
12.1(13)EW Support for interface keyword was added.
12.2(18)EW Enhanced the show idprom interface output to include the hexadecimal display of
the GBIC/SFP SEEPROM contents.
12.2(25)EW Support for the 10-Gigabit Ethernet interface was introduced on the Catalyst 4500
series switch.