Cisco Catalyst 4500 Series - Clear Interface Gigabitethernet

2-102
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
clear interface gigabitethernet
clear interface gigabitethernet
To clear the hardware logic from a Gigabit Ethernet IEEE 802.3z interface, use the clear interface
gigabitethernet command.
Note This command does not increment interface resets as displayed with the show interface
gigabitethernet mod/port command.
clear interface gigabitethernet mod/port
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Examples This example shows how to clear the hardware logic from a Gigabit Ethernet IEEE 802.3z interface:
Switch# clear interface gigabitethernet 1/1
Switch#
Related Commands
mod/port Number of the module and port.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
show interfaces status Displays the interface status.