Cisco Catalyst 4500 Series Command Reference Guide

2-448
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
macro global apply cisco-global
macro global apply cisco-global
To apply the system-defined default template to the switch, use the macro global apply cisco-global
global configuration command on the switch stack or on a standalone switch.
macro global apply cisco-global
Syntax Description This command has no keywords or variables.
Defaults This command has no default setting.
Command Modes Global configuration mode
Command History
Examples These examples show how to apply the system-defined default to the switch:
Switch(config)# macro global apply cisco-global
Changing VTP domain name from gsg-vtp to [smartports] Device mode already VTP TRANSPARENT.
Switch(config)#
Release Modification
12.2(31)SG Support for this command was introduced on the Catalyst 4500 series switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E