Cisco Catalyst 4500 Series Command Reference Guide

2-163
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug platform packet protocol pagp
debug platform packet protocol pagp
To debug the PAgP protocol packets, use the debug platform packet protocol pagp command. To
disable the debugging output, use the no form of this command.
debug platform packet protocol pagp [receive | transmit | vlan]
no debug platform packet protocol pagp [receive | transmit | vlan]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Examples This example shows how to enable all PM debugging:
Switch# debug platform packet protocol pagp
Switch#
Related Commands
receive (Optional) Enables the platform packet reception debugging functions.
transmit (Optional) Enables the platform packet transmission debugging functions.
vlan (Optional) Enables the platform packet VLAN debugging functions.
Release Modification
12.1(13)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
undebug platform packet protocol
pagp (same as no debug platform packet
protocol pagp)
Disables debugging output.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E