2-174
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug spanning-tree uplinkfast
debug spanning-tree uplinkfast
To enable the debugging of the spanning-tree UplinkFast events, use the debug spanning-tree
uplinkfast command. To disable the debugging output, use the no form of this command.
debug spanning-tree uplinkfast [exceptions]
no debug spanning-tree uplinkfast
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines This command is supported only on the supervisor engine and enterable only from the switch console.
Examples This example shows how to debug the spanning tree UplinkFast exceptions:
Switch# debug spanning-tree uplinkfast exceptions
Spanning Tree uplinkfast exceptions debugging is on
Switch#
Related Commands
exceptions (Optional) Enables the debugging of the spanning tree UplinkFast exceptions.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
undebug spanning-tree uplinkfast
(same as no debug spanning-tree
uplinkfast)
Disables debugging output.