Cisco Catalyst 4500 Series - Show Netflow-Lite Sampler

2-868
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show netflow-lite sampler
show netflow-lite sampler
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
To display information about a sampler, use the show netflow-lite sampler command.
show netflow-lite sampler sampler-name
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Examples This example shows how to display information about a sampler,:
Switch# show netflow-lite sampler low-rate
Netflow-lite Sampler low-rate:
Description: Sampler
Sampling rate: 1 out of 256
Packet Section Size: 64 bytes
Packet offset: 0 bytes
Related Commands
sampler-name Specifies a sampler name.
Release Modification
15.0(2)SG Command introduced on the Catalyst 4500 series switch.
Command Description
packet-section size (netflow-lite
sampler submode)
Specifies a sampled header size in netflow-lite submode.
packet-rate (netflow-lite
sampler submode)
Specifies a packet sampling rate in netflow-lite sampler submode.
packet-offset (netflow-lite
sampler submode)
Specifies a starting packet offset in netflow-lite submode.