Cisco Catalyst 4500 Series Command Reference Guide

2-14
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
active
active
To enable the destination profile, use the active command.
active
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes cfg-call-home-profile
Command History
Usage Guidelines By default the profile is enabled upon creation.
Examples This example shows how to enable the destination profile:
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# active
Related Commands
Release Modification
12.2(52)SG Support was introduced on the Catalyst 4500 series switch.
Command Description
destination address Configures the destination e-mail address or URL to which
Call Home messages will be sent.
destination message-size-limit bytes Configures a maximum destination message size for the
destination profile.
destination preferred-msg-format Configures a preferred message format.
destination transport-method Enables the message transport method.
profile Enters profile call-home configuration submode
subscribe-to-alert-group all Subscribes to all available alert groups.
subscribe-to-alert-group configuration Subscribes this destination profile to the Configuration
alert group.
subscribe-to-alert-group diagnostic Subscribes this destination profile to the Diagnostic alert
group.
subscribe-to-alert-group environment Subscribes this destination profile to the Environment alert
group.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E