Cisco Catalyst 4500 Series - Destination Transport-Method

2-194
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
destination transport-method
destination transport-method
To enable the message transport method, use the destination transport-method command.
destination transport-method {email | http}
Syntax Description
Defaults e-mail
Command Modes cfg-call-home-profile
Command History
Usage Guidelines To enter profile call-home configuration submode, use the profile command in call-home configuration
mode.
Examples This example shows how to set the transport method to HTTP:
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# destination transport-method http
Related Commands
email Enables e-mail as transport method.
http Enables HTTP as transport method.
Release Modification
12.2(52)SG Support was introduced on the Catalyst 4500 series switch.
Command Description
destination address Configures the destination e-mail address or URL to which
Call Home messages will be sent.
destination message-size-limit bytes Configures a maximum destination message size for the
destination profile.
destination preferred-msg-format Configures a preferred message format.
profile Enters profile call-home configuration submode
subscribe-to-alert-group all Subscribes to all available alert groups.
subscribe-to-alert-group configuration Subscribes this destination profile to the Configuration
alert group.
subscribe-to-alert-group diagnostic Subscribes this destination profile to the Diagnostic alert
group.
subscribe-to-alert-group environment Subscribes this destination profile to the Environment alert
group.