Cisco Catalyst 4500 Series Command Reference Guide

2-199
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
device-sensor filter-list dhcp
device-sensor filter-list dhcp
To create a DHCP filter containing a list of options that can be included or excluded in the Device Sensor
output, use the device-sensor filter-list dhcp command in global configuration mode. To remove the
DHCP filter containing the list of options, use the no form of this command.
device-sensor filter-list dhcp list option-list-name
no device-sensor filter-list dhcp list option-list-name
Syntax Description
Defaults DHCP options filter list is not available.
Command Modes Global configuration
Command History
Usage Guidelines Use the device-sensor filter-list dhcp command to configure the name of the DHCP options filter list
and enter into DHCP sensor configuration mode. You can configure the list of options in DHCP sensor
configuration mode using the option {name option-name | number option-number} command. Use the
name option-name keyword-argument pair to specify the name of the DHCP option. Use the number
option-number keyword-argument pair to specify the TLV number to be added to the DHCP options
filter list.
Use the no option {name option-name | number option-number} command to remove individual
options from the DHCP options filter list.
Use the no device-sensor filter-list dhcp list option-list-name command to remov the entire options
filter list.
Examples The following example shows how to create a DHCP filter containing a list of options:
Switch> enable
Switch# configure terminal
Switch(config)# device-sensor filter-list dhcp list dhcp-list
Switch(config-sensor-dhcplist)# option name domain-name
Switch(config-sensor-dhcplist)# option name host-name
Switch(config-sensor-dhcplist)# option number 50
Switch(config-sensor-dhcplist)# end
list Contains a DHCP options filter list.
option-list-name DHCP options filter list name.
Release Modification
IOS XE 3.4.0SG and
IOS 15.1(2)SG)
Command introduced on the Catalyst 4500 Series switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E