Cisco Catalyst 4500 Series Command Reference Guide

1-2
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 1 Command-Line Interface
How to Find Command Options
How to Find Command Options
This section provides an example of how to display syntax for a command. The syntax can consist of
optional or required keywords. To display keywords for a command, enter a question mark (?) at the
command prompt or after entering part of a command followed by a space. The Catalyst 4500 series
switch software displays a list of available keywords along with a brief description of the keywords. For
example, if you are in global configuration mode and want to see all the keywords for the arap
command, you enter arap ?.
Table 1-2 shows examples of how you can use the question mark (?) to assist you in entering commands
and also guides you through entering the following commands:
• interface gigabitethernet 1/1
• channel-group 1 mode auto
Table 1-2 How to Find Command Options
Command Purpose
Switch> enable
Password: <password>
Switch#
Enter the enable command and
password to access privileged EXEC
commands.
You are in privileged EXEC mode
when the prompt changes to
Switch#.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
Enter global configuration mode.
You are in global configuration mode
when the prompt changes to
Switch(config)#.
Switch(config)# interface gigabitethernet ?
<1-9> GigabitEthernet interface number
Switch(config)# interface gigabitethernet 1/1
Switch(config-if)#
Enter interface configuration mode by
specifying the Gigabit Ethernet
interface that you want to configure
using the interface gigabitethernet
global configuration command.
Enter a ? to display what you must
enter next on the command line. In
this example, you must enter an
interface number from 1 to 9 in the
format module-number/port-number.
You are in interface configuration
mode when the prompt changes to
Switch(config-if)#.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E