Cisco Catalyst 4500 Series Command Reference Guide

2-450
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
macro global description
macro global description
To enter a description about the macros that are applied to the switch, use the macro global description
global configuration command on the switch stack or on a standalone switch. Use the no form of this
command to remove the description.
macro global description text
no macro global description text
Syntax Description
Defaults This command has no default setting.
Command Modes Global configuration mode
Command History
Usage Guidelines This command associates comment text, or the macro name, with a switch. When multiple macros are
applied on a switch, the description text will be from the last applied macro.
Examples This example shows how to add a description to a switch:
Switch(config)# macro global description udld aggressive mode enabled
You can verify your settings by entering the show parser macro description privileged EXEC
command.
Related Commands
text Enters a description about the macros that are applied to the switch.
Release Modification
12.2(31)SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
macro global apply cisco-global Applies the system-defined default template to the switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E