Cisco Catalyst 4500 Series - Show Netflow-Lite Monitor

2-866
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show netflow-lite monitor
show netflow-lite monitor
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
To display information about a particular packet or per data source stats, use the show netflow-lite
monitor command.
show netflow-lite monitor monitor-number interface interface-name
show netflow-lite monitor monitor-number vlan vlan-id
Syntax Description
Defaults None
Command Modes Privileged EXEC mode
Command History
Usage Guidelines This command displays information about a particular packet or per data source stats. The interface can
be either a physical port or a VLAN.
This command displays the following packet sampling statistics:
• Total # of packet (samples) exported
• Total # of packet (samples) dropped due to lack of local resources
• Total# of packets seen at the data source
The packetsObserved statistic accounts for packets that are dropped by input ACL or QoS policer.
The exported packets only represent samples from the non-dropped packet population.
Examples These examples show how to display information about a particular packet or per data source stats:
Switch# show netflow-lite monitor 1 interface gi1/3
Interface GigabitEthernet1/3:
Netflow-lite Monitor-1:
Active: TRUE
Sampler: sampler1
Exporter: exporter1
Average Packet Size: 0
monitor-number Specifies a monitor name.
interface-name Specifies an interface.
vlan-id Specifies a VLAN.
Release Modification
15.0(2)SG Command introduced on the Catalyst 4500 series switch.