Cisco Catalyst 4500 Series - Ip Igmp Snooping Vlan Mrouter

2-338
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip igmp snooping vlan mrouter
ip igmp snooping vlan mrouter
To statically configure an Layer 2 interface as a multicast router interface for a VLAN, use the
ip igmp snooping vlan mrouter command. To remove the configuration, use the no form of this
command.
ip igmp snooping vlan vlan-id mrouter {interface {{fastethernet slot/port} | {gigabitethernet
slot/port} | {tengigabitethernet slot/port} | {port-channel number}} |
{learn {cgmp | pim-dvmrp}}
no ip igmp snooping vlan vlan-id mrouter {interface {{fastethernet slot/port} | {gigabitethernet
slot/port} | {tengigabitethernet slot/port} | {port-channel number}} |
{learn {cgmp | pim-dvmrp}}
Syntax Description
Defaults Multicast switch snooping PIM-DVMRP packets are specified.
Command Modes Interface configuration mode
Command History
vlan vlan-id
Specifies the VLAN ID number to use in the command; valid values are
from 1 to 4094.
interface Specifies the next-hop interface to a multicast switch.
fastethernet slot/port Specifies the Fast Ethernet interface; number of the slot and port.
gigabitethernet slot/port Specifies the Gigabit Ethernet interface; number of the slot and port.
tengigabitethernet
slot/port
Specifies the 10-Gigabit Ethernet interface; number of the slot and port.
port-channel number Port-channel number; valid values are from 1 to 64.
learn Specifies the multicast switch learning method.
cgmp Specifies the multicast switch snooping CGMP packets.
pim-dvmrp Specifies the multicast switch snooping PIM-DVMRP packets.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(12c)EW Support for extended addressing was added.
12.2(25)EW Support for the 10-Gigabit Ethernet interface was introduced on the Catalyst 4500
series switch.