Cisco Catalyst 4500 Series Command Reference Guide

2-287
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
interface (virtual switch)
interface (virtual switch)
To select an interface to configure and enter interface configuration mode, use the interface global
configuration mode command.
interface [interface switch-num/slot/port.subinterface}
Syntax Description
Defaults No interface types are configured.
Command Modes Global configuration mode
Command History
Usage Guidelines Table 2-9 lists the valid values for type.
interface Specifies the interface to be configured; see Table 2-9 for valid values.
switch-num Specifies a switch ID.
slot Specifies a slot number.
port Specifies a port number.
.subinterface Specifies the port subinterface number.
Release Modification
Cisco IOS XE 3.4.0SG and
15.1(2)SG
Support introduced on the Catalyt 4500 Series Switch.
Table 2-9 Valid type Values
Keyword Definition
fastethernet Fast Ethernet 802.3
gigabitethernet Gigabit Ethernet IEEE 802.3z interface.
tengigabitethernet 10-Gigabit Ethernet IEEE 802.3ae interface.
vlan VLAN interface; see the interface vlan command.
port-channel Port channel interface; see the interface port-channel command.
null Null interface; the valid value is 0.
tunnel Tunnel interface

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E