Cisco Catalyst 4500 Series - Clear Netflow-Lite Monitor Statistics Interface

2-122
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
clear netflow-lite monitor statistics interface
clear netflow-lite monitor statistics interface
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
To clear statistics of a packet sampler at a monitor, use the clear netflow-lite monitor statistics
interface command.
clear netflow-lite monitor statistics interface vlan-id
Syntax Description
Defaults None
Command Modes Privileged EXEC mode
Command History
Examples The following examples show how to clear statistics of a packet sampler at a monitor:
Switch# clear netflow-lite monitor 1 statistics int gi1/1
Switch# clear netflow-lite monitor 1 statistics vlan 10
Related Commands
vlan-id Specifies an interface.
Release Modification
15.0(2)SG Command introduced on the Catalyst 4948E and Catalyst 4948E-F Ethernet
switches.
Command Description
clear netflow-lite exporter
statistics
Clear the collector statistics.