Cisco Catalyst 4500 Series - Profile

2-573
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
profile
profile
To enter profile call-home configuration submode, use the profile command in call-home configuration
mode, use the profile command.
profile profile_name
Syntax Description
Defaults This command has no default settings.
Command Modes cfg-call-home
Command History
Usage Guidelines When you enter the profile profile_name command in call-home mode, the prompt changes to
Switch(cfg-call-home-profile)#, and you have access to the following profile configuration commands:
• active
• destination address
• destination message-size-limit bytes
• destination preferred-msg-format
• destination transport-method
• end
• exit
• subscribe-to-alert-group all
• subscribe-to-alert-group configuration
• subscribe-to-alert-group diagnostic
• subscribe-to-alert-group environment
• subscribe-to-alert-group inventory
• subscribe-to-alert-group syslog
profile_name Specifies the profile name.
Release Modification
12.2(52)SG Support for this command was introduced on the Catalyst 4500 series switch.