Cisco Catalyst 4500 Series Command Reference Guide

2-5
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
aaa accounting system default start-stop group radius
aaa accounting system default start-stop group radius
To receive the session termination messages after the switch reboots, use the aaa accounting system
default start-stop group radius command. To disable accounting, use the no form of this command.
aaa accounting system default start-stop group radius
no aaa accounting system default start-stop group radius
Syntax Description This command has no arguments or keywords.
Defaults Accounting is disabled.
Command Modes Global configuration mode
Command History
Usage Guidelines 802.1X accounting requires the RADIUS server.
This command enables the AAA client’s accounting feature to forward 802.1X update and watchdog
packets from the 802.1X supplicant (workstation client) to the authentication (RADIUS) server.
(Watchdog packets are defined as EAPOL-LOGON, EAPOL-LOGOFF, and EAPOL-INTERIM
messages.) Successful authentication and authorization of the supplicant by the authentication server is
required before these packets are considered valid and are forwarded. When the client is reauthenticated,
an interim-update accounting notice is sent to the accounting server.
Examples This example shows how to generate a logoff after a switch reboots:
Switch(config)# aaa accounting system default start-stop group radius
Note The RADIUS authentication server must be properly configured to accept and log update or watchdog
packets from the AAA client.
Related Commands
Release Modification
12.2(18)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
aaa accounting dot1x default
start-stop group radius
Enables accounting for 802.1X authentication sessions.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E