Cisco Catalyst 4500 Series - Logging Event Link-Status Global (Global Configuration)

2-402
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
logging event link-status global (global configuration)
logging event link-status global (global configuration)
To change the default switch-wide global link-status event messaging settings, use the
logging event link-status global command. Use the no form of this command to disable the link-status
event messaging.
logging event link-status global
no logging event link-status global
Syntax Description This command has no arguments or keywords.
Defaults The global link-status messaging is disabled.
Command Modes Global configuration mode
Command History
Usage Guidelines If link-status logging event is not configured at the interface level, this global link-status setting takes
effect for each interface.
Examples This example shows how to globally enable link status message on each interface:
Switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# logging event link-status global
Switch(config)# end
Switch#
Related Commands
Release Modification
12.2(25)SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
logging event link-status (interface
configuration)
Enables the link-status event messaging on an interface.