Cisco Catalyst 4500 Series Command Reference Guide

2-842
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show mac-address-table vlan
show mac-address-table vlan
To display information about the MAC address table for a specific VLAN, use the show
mac-address-table vlan command.
show mac-address-table [vlan vlan_id] [protocol protocol]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines For the MAC address table entries used by the routed ports, the routed port name is displayed in the
“vlan” column not the the internal VLAN number.
The keyword definitions for the protocol variable are as follows:
• assigned specifies the assigned protocol entries.
• ip specifies the IP protocol.
• ipx specifies the IPX protocols.
• other specifies the other protocol entries.
vlan vlan_id (Optional) Displays the entries for a specific VLAN; valid values are from 1 to
4094.
protocol protocol (Optional) Specifies a protocol. See the “Usage Guidelines” section for more
information.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(12c)EW Support for extended addressing was added.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E