Cisco Catalyst 4500 Series - Show Call-Home

2-655
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show call-home
show call-home
To display the configured CallHome information, use the show call-home command in privileged EXEC
mode.
show call-home [alert-group | detail | mail-server | profile {all | name} | statistics]
Syntax Description
Command Default This command has no default settings.
Command Modes Privileged EXEC (#)
Command History
Examples The following example displays the configured CallHome settings:
Switch# show call-home
Current call home settings:
call home feature : disable
call home message's from address: switch@example.com
call home message's reply-to address: support@example.com
vrf for call-home messages: Not yet set up
contact person's email address: technical@example.com
contact person's phone number: +1-408-555-1234
street address: 1234 Picaboo Street, Any city, Any state, 12345
customer ID: ExampleCorp
contract ID: X123456789
site ID: SantaClara
Mail-server[1]: Address: smtp.example.com Priority: 1
Mail-server[2]: Address: 192.168.0.1 Priority: 2
Rate-limit: 20 message(s) per minute
alert-group (Optional) Displays the available alert group.
detail (Optional) Displays the CallHome configuration in detail.
mail-server (Optional) Displays the CallHome mail server-related information.
profile all (Optional) Displays configuration information for all existing profiles.
profile name (Optional) Displays configuration information for a specific destination
profile.
statistics (Optional) Displays the CallHome statistics.
Release Modification
12.2(52)SG This command was introduced on the Catalyst 4500 series switch,
Supervisor Engine 6-E, and Catalyst 4900M chassis.