EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #783 background imageLoading...
Page #783 background image
2-725
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show interfaces transceiver
show interfaces transceiver
To display diagnostic-monitoring data for all interfaces that have transceivers installed, use the show
interfaces transceiver command.
show interfaces {{[int_name] transceiver {[detail]} | {transceiver [module mod] | detail
[module mod]}}
Syntax Description
Defaults The noninterface-specific versions of the show interfaces transceiver command are enabled by default.
The interface-specific versions of these commands are enabled by default if the specified interface has
a transceiver (GBIC or SFP) that is configured for diagnostic monitoring, and the transceiver is in a
module that supports diagnostic monitoring.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines The show interfaces transceiver command provides useful information under the following conditions:
• At least one transceiver is installed on a chassis that is configured for diagnostic monitoring.
• The transceiver is in a module that supports diagnostic monitoring.
If you notice that the alarm and warning flags have been set on a transceiver, reenter the command to
confirm.
int_name (Optional) Interface name.
detail (Optional) Displays the calibrated values and the A2D readouts if the readout values
differ from the calibrated values. Also displays the high-alarm, high-warning,
low-warning, and low-alarm thresholds.
module mod (Optional) Limits the display to interfaces on a specific module.
Release Modification
12.1(20)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.2(18)EW Support for the calibration keyword was withdrawn.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals