Cisco Catalyst 4500 Series Command Reference Guide

2-643
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show arp access-list
show arp access-list
To display detailed information on an ARP access list, use the show arp command.
show arp access-list
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes EXEC
Command History
Examples This example shows how to display the ARP ACL information for a switch:
Switch# show arp access-list
ARP access list rose
permit ip 10.101.1.1 0.0.0.255 mac any
permit ip 20.3.1.0 0.0.0.255 mac any
Related Commands
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series
switch.
Command Description
access-group mode Specifies the override modes (for example, VACL overrides
PACL) and the non-override modes (for example, merge or strict
mode).
arp access-list Defines an ARP access list or adds clauses at the end of a
predefined list.
ip arp inspection filter vlan Permits ARPs from hosts that are configured for static IP when
DAI is enabled, defines an ARP access list, and applies the access
list to a VLAN.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E