EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1102 background imageLoading...
Page #1102 background image
2-1044
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
switchport access vlan
switchport access vlan
To set the VLAN when an interface is in access mode, use the switchport access vlan command. To
reset the access mode VLAN to the appropriate default VLAN for the device, use the no form of this
command.
switchport access [vlan {vlan-id | dynamic}]
no switchport access vlan
Syntax Description
Defaults The default settings are as follows:
• The access VLAN and trunk interface native VLAN are default VLANs that correspond to the
platform or the interface hardware.
• All VLAN lists include all VLANs.
Command Modes Interface configuration mode
Command History
Usage Guidelines You must enter the switchport command without any keywords to configure the LAN interface as a
Layer 2 interface before you can enter the switchport access vlan command. This action is required only
if you have not already entered the switchport command for the interface.
Entering the no switchport command shuts the port down and then reenables it, which could generate
messages on the device to which the port is connected.
The no form of the switchport access vlan command resets the access mode VLAN to the appropriate
default VLAN for the device.
Valid values for vlan-id are from 1 to 4094.
Examples This example shows how to cause the port interface to stop operating as a Cisco-routed port and convert
to a Layer 2-switched interface:
Switch(config-if)# switchport
Switch(config-if)#
vlan-id (Optional) Number of the VLAN on the interface in access mode; valid values are from
1 to 4094.
dynamic (Optional) Enables VMPS control of the VLAN.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(13)EW Support for VPMS was added.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals