2-1045
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
switchport access vlan
Note This command is not used on platforms that do not support Cisco-routed ports. All physical ports on such
platforms are assumed to be Layer 2-switched interfaces.
This example shows how to cause a port interface that has already been configured as a switched
interface to operate in VLAN 2 instead of the platform’s default VLAN when in access mode:
Switch(config-if)# switchport access vlan 2
Switch(config-if)#
Related Commands Command Description
show interfaces switchport Displays the administrative and operational status of a
switching (nonrouting) port.
To Next Page
Loading...
