EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #281 background imageLoading...
Page #281 background image
2-223
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
dot1x max-req
dot1x max-req
To set the maximum number of times that the switch retransmits an Extensible Authentication Protocol
(EAP)-Request frame of types other than EAP-Request/Identity to the client before restarting the
authentication process, use the dot1x max-req command. To return to the default setting, use the no
form of this command.
dot1x max-req count
no dot1x max-req
Syntax Description
Defaults The switch sends a maximum of two retransmissions.
Command Modes Interface configuration mode
Command History
Usage Guidelines You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
You can verify your settings by entering the show dot1x privileged EXEC command.
Examples This example shows how to set 5 as the number of times that the switch retransmits an EAP-Request
frame before restarting the authentication process:
Switch(config-if)# dot1x max-req 5
Switch(config-if)#
This example shows how to return to the default setting:
Switch(config-if)# no dot1x max-req
Switch(config-if)#
count Number of times that the switch retransmits EAP-Request frames of types other than
EAP-Request/Identity before restarting the authentication process; valid values are from
1 to 10.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(19)EW This command was modified to control on EAP-Request/Identity retransmission
limits.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals