Cisco Catalyst 4500 Series Command Reference Guide

2-486
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
name
name
To set the MST region name, use the name command. To return to the default name, use the no form of
this command.
name name
no name name
Syntax Description
Defaults The MST region name is not set.
Command Modes MST configuration mode
Command History
Usage Guidelines Two or more Catalyst 4500 series switches with the same VLAN mapping and configuration version
number are considered to be in different MST regions if the region names are different.
Examples This example shows how to name a region:
Switch(config-mst)# name Cisco
Switch(config-mst)#
Related Commands
name Specifies the name of the MST region. The name can be any string with a maximum
length of 32 characters.
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
instance Maps a VLAN or a set of VLANs to an MST instance.
revision Sets the MST configuration revision number.
show spanning-tree mst Displays MST protocol information.
spanning-tree mst
configuration
Enters the MST configuration submode.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E