Cisco Catalyst 4500 Series Command Reference Guide

2-487
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
netflow-lite exporter
netflow-lite exporter
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
To define an exporter and to enter NetFlow-lite exporter submode, use the netflow-lite exporter
command. To delete an exporter, use the no form of this command.
netflow-lite exporter exporter
no netflow-lite exporter exporter
Syntax Description
Defaults None
Command Modes global configuration mode
Command History
Usage Guidelines The exporter's name identifies the exporter. Mandatory parameters for a minimal complete exporter
configuration are the destination IP address of the collector, source IP address (on the switch) to use and
UDP destination port of the collector. Any unspecified non-mandatory parameters take on default values.
The exporter name can be specified when activating sampling at a data source via the monitor command.
The exporter submode also allows you to specify the refresh frequency for the NetFlow templates.
Metadata about the NetFlow packet sampling process like sampler configuration parameters and snmp
interface table mapping can also be exported periodically to the collector.
Deleting or removing the value of a non-mandatory parameter restores the default.
Examples This example shows how to configure an NetFlow exporter:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
exporter Specifies an exporter.
Release Modification
15.0(2)SG Support for this command was introduced on the Catalyst 4500 series switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E