2-213
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
dot1x critical eapol
dot1x critical eapol
To enable sending EAPOL success packets when a port is critically authorized partway through an EAP
exchange, use the dot1x critical eapol command. To return to the default setting, use the no form of this
command.
dot1x critical eapol
no dot1x critical eapol
Syntax Description This command has no keywords or variables.
Defaults The default is to not send EAPOL success packets.
Command Modes Global configuration mode
Command History
Examples This example shows how to enable sending EAPOL success packets:
Switch(config-if)# dot1x critical eapol
Switch(config-if)#
Related Commands
Release Modification
12.2(31)SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
dot1x critical Enables the 802.1X critical authentication on a port.
dot1x critical recovery delay Sets the time interval between port reinitializations.
dot1x critical vlan Assigns a critically authenticated port to a specific VLAN.
show dot1x Displays dot1x information.