Cisco Catalyst 4500 Series Command Reference Guide

2-401
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
lldp tlv-select power-management
lldp tlv-select power-management
To to enable power negotiation through LLDP, use the lldp tlv-select power-management interface
command.
lldp tlv-select power-management
Syntax Description
Defaults Enabled on POEP ports
Command Modes Interface level
Command History
Usage Guidelines You need to disable this feature if you do not want to perform power negotiation through LLDP.
This feature is not supported on non-POEP ports; the CLI is suppressed on such ports and TLV is not
exchanged.
Examples This example shows how to enable LLDP power negotiation on interface Gigabit Ethernet 3/1:
Switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# int gi 3/1
Switch(config-if)# lldp tlv-select power-management
Related Commands
This command has no arguments or keywords.
Release Modification
12.2(54)SG Support was introduced on the Catalyst 4500 series switch.
Command Description
lldp run Cisco IOS Command Reference library.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E