2-642
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show ancp multicast
show ancp multicast
To display multicast streams activated by Access Node Control Protocol (ANCP), use the show ancp
multicast command.
show ancp multicast [group groupaddr] [source sourceaddr] | [ interface interfacename]
Syntax Description
Defaults Displays all the multicast streams activated with ANCP.
Command Modes Privileged EXEC
Command History
Examples This example shows how to display multicast streams activated by ANCP:
ANCP-Client# show ancp mul
ANCP Multicast Streams
ClientID VLAN Interface Joined on
Group 235.3.2.1
0x01060004000A0703 10 Fa7/3 18:27:35 UTC Sat Sep 13 2008
0x0106000400140703 20 Fa7/3 18:27:35 UTC Sat Sep 13 2008
0x01060004000A0704 10 Fa7/4 18:25:43 UTC Sat Sep 13 2008
0x0106000400140704 20 Fa7/4 18:25:43 UTC Sat Sep 13 2008
Group 238.1.2.3
0x01060004000A0703 10 Fa7/3 18:27:37 UTC Sat Sep 13 2008
0x0106000400140703 20 Fa7/3 18:27:35 UTC Sat Sep 13 2008
0x01060004000A0704 10 Fa7/4 18:25:43 UTC Sat Sep 13 2008
0x0106000400140704 20 Fa7/4 18:25:43 UTC Sat Sep 13 2008
ANCP-Client#
group groupaddr (Optional) Specifies a multicast group address.
source sourceaddr (Optional) Specifies a multicast source address.
interface interfacename (Optional) Specifies a multicast flowing on a specific interface.
Release Modification
12.2(50)SG Support for this command was introduced on the Catalyst 4500 series
switch.