Cisco Catalyst 4500 Series Command Reference Guide

2-552
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
pppoe intermediate-agent (global)
pppoe intermediate-agent (global)
To enable the PPPoE Intermediate Agent feature on a switch, use the pppoe intermediate-agent global
configuration command. To disable the feature, use the no form of this command.
pppoe intermediate-agent
no pppoe intermediate-agent
Syntax Description This command has no arguments or keywords.
Defaults disabled
Command Modes Global configuration mode
Command History
Usage Guidelines You must enable PPPoE Intermediate Agent globally on a switch before you can use
PPPoE Intermediate Agent on an interface or interface VLAN.
Examples This example shows how to enable PPPoE Intermediate Agent on a switch:
Switch(config)# pppoe intermediate-agent
This example shows how to disable PPPoE Intermediate Agent on a switch:
Switch(config)# no pppoe intermediate-agent
Related Commands
Release Modification
12.2(50)SG Support for this command was introduced on the Catalyst 4500 series
switch.
Command Description
pppoe intermediate-agent
(global)
Sets the access node identifier, generic error message, and
identifier string for a switch.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E