Cisco Catalyst 4500 Series Command Reference Guide

2-551
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
power redundancy-mode
Examples This example shows how to set the power management mode to combined:
Switch(config)# power redundancy-mode combined
Switch(config)#
Related Commands
One side at 220VAC + 220VAC +
220VAC, the other at 220VAC +
220VAC
2939 11250 13440
One side at 220VAC + 220VAC +
220VAC, the other at 220VAC
2168 8300 9890
One side at 220VAC + 220VAC, the
other at 220VAC
2168 6225 7410
1. Power supply output drawings should not exceed the total power.
Table 2-18 Power Output in Combined Mode for the 9000 W AC Power Supply
Power Supply 12V (data) (W) -50V (PoE) (W)
1
Total Power
(W)
Command Description
show power Displays information about the power status.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E