Cisco Catalyst 4500 Series - Pppoe Intermediate-Agent Format-Type (Interface)

2-558
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
pppoe intermediate-agent format-type (interface)
pppoe intermediate-agent format-type (interface)
Note This command takes effect only if you enable the pppoe intermediate-agent interface configuration
command.
To set circuit-id or remote-id for an interface, use the pppoe intermediate-agent format-type
command. To unset the parameters, use the no form of this command.
pppoe intermediate-agent format-type {circuit-id | remote-id} string string
no pppoe intermediate-agent format-type {circuit-id | remote-id} string string
Syntax Description
Defaults No default values for circuit-id and remote-id.
Command Modes Interface configuration mode
Command History
Usage Guidelines Use the pppoe intermediate-agent format-type command to set interface-specific circuit-id and
remote-id values. If an interface-specific circuit-id is not set, the system's automatic generated circuit-id
value is used.
Examples This example shows how to set remote-id for an interface:
Switch(config-if)# pppoe intermediate-agent format-type remote-id string user5551983
This example shows how to unset circuit-id for an interface:
Switch(config)# no pppoe intermediate-agent format-type circuit-id
Related Commands
circuit-id string string ASCII string literal value for circuit-id.
remote-id string string ASCII string literal value for remote-id.
Release Modification
12.2(50)SG Support for this command was introduced on the Catalyst 4500 series
switch.
Command Description
pppoe intermediate-agent
(interface)
Enables the PPPoE Intermediate Agent feature on an interface.
pppoe intermediate-agent
(interface vlan-range)
Sets the circuit-id or remote-id for an interface vlan-range.