Cisco Catalyst 4500 Series - Show Qos

2-902
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show qos
show qos
To display QoS information, use the show qos command.
show qos
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines This command is not supported on the Supervisor Engine 6-E and Catalyst 4900M chassis.
Examples This example shows the output that might be displayed if you do not enter any keywords:
Switch# show qos
QoS is enabled globally
Switch#
Related Commands
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
qos account layer-all encapsulation Globally enables QoS functionality on the switch.