Cisco Catalyst 4500 Series Command Reference Guide

2-192
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
destination preferred-msg-format
destination preferred-msg-format
To configure a preferred message format, use the destination preferred-msg-format command.
destination preferred-msg-format {long-text | short-text | xml}
Syntax Description
Defaults xml
Command Modes cfg-call-home-profile
Command History
Usage Guidelines To enter profile call-home configuration submode, use the profile command in call-home configuration
mode.
Examples This example shows how to configure the preferred message format as long text:
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# destination preferred-msg-format long-text
Switch(cfg-call-home-profile)#
Related Commands
long-text Sends the message in long-text format.
short-text Sends the message in short-text format.
xml Sends the message in XML format.
Release Modification
12.2(52)SG Support was introduced on the Catalyst 4500 series switch.
Command Description
destination address Configures the destination e-mail address or URL to which
Call Home messages will be sent.
destination message-size-limit bytes Configures a maximum destination message size for the
destination profile.
destination transport-method Enables the message transport method.
profile Enters profile call-home configuration submode
subscribe-to-alert-group all Subscribes to all available alert groups.
subscribe-to-alert-group configuration Subscribes this destination profile to the Configuration
alert group.
subscribe-to-alert-group diagnostic Subscribes this destination profile to the Diagnostic alert
group.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E