Cisco Catalyst 4500 Series - Debug Nmsp

2-159
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug nmsp
debug nmsp
To the enable debugging of the Network Mobility Services Protocol (NMSP) on the switch, use the
debug nmsp command. This command is available only when your switch is running the cryptographic
(encrypted) software image. Use the no form of this command to disable debugging.
debug nmsp {all | connection | error | event | packet | rx | tx}
no debug nmsp
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines The undebug nmsp command is the same as the no debug nmsp command.
Related Commands
Release Modification
12.2(52)SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show nmsp Displays the NMSP information.