Cisco Catalyst 4500 Series Command Reference Guide

2-494
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
nmsp attachment suppress
nmsp attachment suppress
To suppress reporting attachment information from a specified interface, use the nmsp attachment
suppress interface command. This command is available only when your switch is running the
cryptographic (encrypted) software image. Use the no form of this command to report attachment
information.
nmsp attachment suppress
no nmsp attachment suppress
Syntax Description This command has no arguments or keywords.
Defaults Attachment information is reported.
Command Modes Interface configuration mode
Command History
Usage Guidelines Use the nmsp attachment suppress interface configuration command to configure an interface to not
send attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples This example shows how to configure an interface to not send attachment information to the MSE:
Switch(config)# switch interface gigabitethernet1/2
Switch(config-if)# nmsp attachment suppress
Switch(config-if)#
Related Commands
Release Modification
12.2(52)SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
nmsp Configures Network Mobility Services Protocol (NMSP) on the
switch.
show nmsp Displays the NMSP information.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E