2-553
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
pppoe intermediate-agent (interface)
pppoe intermediate-agent (interface)
Note This command takes effect only if you enable the pppoe intermediate-agent global command.
To enable the PPPoE Intermediate Agent feature on an interface, use the pppoe intermediate-agent
command. To disable the feature, use the no form of this command.
pppoe intermediate-agent
no pppoe intermediate-agent
Syntax Description This command has no arguments or keywords.
Defaults Disabled on all interfaces.
Command Modes Interface configuration mode
Command History
Usage Guidelines PPPoE Intermediate Agent is enabled on an interface provided the PPPoE Intermediate Agent is enabled
both on the switch and the interface.
Examples This example shows how to enable the PPPoE Intermediate Agent on an interface:
Switch(config-if)# pppoe intermediate-agent
This example shows how to disable the PPPoE Intermediate Agent on an interface:
Switch(config-if)# no pppoe intermediate-agent
Related Commands
Release Modification
12.2(50)SG Support for this command was introduced on the Catalyst 4500 series
switch.
Command Description
pppoe intermediate-agent
format-type (interface)
Sets circuit ID or remote ID for an interface.
pppoe intermediate-agent
limit rate
Limits the rate of the PPPoE Discovery packets coming on an
interface.