Cisco Catalyst 4500 Series - Pppoe Intermediate-Agent (Interface Vlan-Range)

2-555
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
pppoe intermediate-agent (interface vlan-range)
pppoe intermediate-agent (interface vlan-range)
Note This command takes effect only if you enable the pppoe intermediate-agent global command.
To enable PPPoE Intermediate Agent on an interface VLAN range, use the pppoe intermediate-agent
global command. To disable the feature, use the no form of this command.
pppoe intermediate-agent
no pppoe intermediate-agent
Syntax Description This command has no arguments or keywords.
Defaults Disabled on all VLANs on all interfaces
Command Modes Interface vlan-range configuration mode
Command History
Usage Guidelines Although this command takes effect irrespective of the pppoe intermediate-agent (interface
configuration mode) command, you must enable the pppoe intermediate-agent (global configuration
mode) command.
Examples This example shows how to enable PPPoE Intermediate Agent on a range of VLANs:
Switch(config-if)# vlan-range 167-368
Switch(config-if-vlan-range)# pppoe intermediate-agent
This example shows how to disable PPPoE Intermediate Agent on a single VLAN:
Switch(config-if)# vlan-range 268
Switch(config-if-vlan-range)# no pppoe intermediate-agent
Related Commands
Release Modification
12.2(50)SG Support for this command was introduced on the Catalyst 4500 series
switch.
Command Description
pppoe intermediate-agent
(interface)
Enables the PPPoE Intermediate Agent feature on an interface.