Cisco Catalyst 4500 Series - Ancp Mode Client

2-18
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ancp mode client
ancp mode client
To set the router to become an ANCP client, use the ancp mode client command.
ancp mode client
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes Global configuration mode
Command History
Usage Guidelines To fully activate ANCP, the administrator must also set the ANCP server IP address to which the ANCP
client must connect.
Examples This example shows how to set the router to become an ANCP client:
Switch# ancp mode client
Related Commands
Release Modification
12.2(50)SG Support for this command was introduced on the Catalyst 4500 series
switch.
Command Description
ancp client server Displays multicast streams activated by ANCP.