Cisco Catalyst 4500 Series - Subscribe-To-Alert-Group Configuration

2-1026
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
subscribe-to-alert-group configuration
subscribe-to-alert-group configuration
To subscribe a destination profile to the Configuration alert group, use the
subscribe-to-alert-group configuration command.
subscribe-to-alert-group configuration [periodic {daily hh:mm | monthly date hh:mm | weekly
day hh:mm}]
Syntax Description
Defaults This command has no default settings.
Command Modes cfg-call-home-profile
Command History
Usage Guidelines To enter profile call-home configuration submode, use the profile command in call-home configuration
mode.
The Configuration alert group can be configured for periodic notification.
Examples This example shows how to configure periodic "configuration" alert-group:
Switch(config)# call-home
Switch(cfg-call-home)# profile cisco
Switch(cfg-call-home-profile)# subscribe-to-alert-group configuration periodic weekly
Tuesday 21:16
Related Commands
periodic (Optional) Specifies a periodic call-home message.
daily hh:mm Sets a daily alert in hours and minutes.
monthly date hh:mm Sets a monthly alert in day, hour, and minute.
weekly day hh:mm Sets a weekly alert in day, hour, and minutes.
Release Modification
12.2(52)SG Support was introduced on the Catalyst 4500 series switches.
Command Description
destination address Configures the destination e-mail address or URL to which
Call Home messages will be sent.
destination message-size-limit bytes Configures a maximum destination message size for the
destination profile.
destination preferred-msg-format Configures a preferred message format.
destination transport-method Enables the message transport method.
profile Enters profile call-home configuration submode
subscribe-to-alert-group all Subscribes to all available alert groups.